Oki B2200 - Loading Paper in the Tray; Loading Paper in the Manual Feeder

Print media > 9
The paper tray can hold up to about 150 sheets of standard bond
paper. The manual feeder takes just one sheet at a time. Take
just enough paper from its wrapping, fan the stack to ensure all
sheets are separated from each other, then tap the stack flush
again before loading.
Load pre-printed stationery top edge first and face down into the
paper tray or face up into the manual feeder.
If plain paper seems to curl excessively during the print process,
try turning the stack over in the input tray. You may have been
printing on the wrong side.
L OADING PAPER IN THE TRAY
1. Remove up to 150 sheets from their wrapping and
carefully reseal the wrapping to preserve the rest of your
paper in good condition.
2. Fan the paper stack to ensure all sheets are properly
separated, then tap the stack flush again before loading.
3. Raise the paper tray cover.
4. Adjust guides to width of paper stack. They should just
touch the sides of the stack but not grip it tightly.