32
SET XXX ON MPTRAY
AND PUSH ON-LINE SWITCH
The printer has received a job for
printing from the Multi-Purpose
Tray and no media is loaded in the
tray.
What to Do
Load the requested media (
xxx
) in
the Multi-Purpose Tray, then press
ON LINE.
t NEAR END
Appears on the second line of the
display to indicate that the media in
tray t is almost out.
What to Do
Load more media in the tray before
printing any large print jobs from
that tray.
REMOVE THE PAPER
480: STACKER FULL
The stack of paper in the top (face
down) output tray is blocking the
printed sheets trying to exit the
printer.
What to Do
Remove the stack of printed sheets
from the top output tray.
CHECK FUSER UNIT
320: FUSER UNIT MISSING
The fuser is not properly installed.
What to Do
Open the top cover and check the
fuser:
1. Press down on the fuser to be
sure it is firmly locked in place.
The message should disappear.
Note:
If the message still appears,
push the blue latches at
either end of the fuser back
(toward the printer cover
hinge) and lift the fuser out,
then lower it back into the
printer, pushing it firmly
down in place. You should
feel the latches at either end
engage.
2. Close the cover.
Error Messages (cont.)
To Next Page
Loading...
Need help?
General
