Windows> 26
address is entered, the Port Name will default to
IP_192.168.1.31.
7. Click Next. “Additional Port Information Required” is
displayed.
8. Under “Device Type”, select Custom and click Settings.
9. Depending on whether you are installing the Windows
Standard TCP/IP Port using LPR or Port 9100, enter the
following details:
LPR
> Set “Protocol” to LPR.
> Under “LPR Settings”, enter Queue Name: ‘lp’ and ensure
that “SNMP Status Enabled” is not selected.
Port 9100
> Set “Protocol” to Raw.
> Ensure that the “Port Number” is 9100 and that “SNMP
Status Enabled” is not selected.
10. Click OK.
11. Click Next.
12. Click Finish and follow the instructions on the screen to
finish installing the printer.
To Next Page
Loading...
