Oki C3600n Setup Guide

C3600n Setup Guide
7
The Operation Panel
The Operation Panel allows operator
intervention and indicates both when the
printer is operating normally and when it
requires attention. Detailed printer status
is provided by the Status Monitor in
Windows or Printer Driver in Macintosh.
The Operation Panel incorporates 2 LEDs,
a two-line LCD, and 6 push-buttons as
follows (from left to right):
1 ATTENTION LED (amber):
2 ON LINE LED (green)
3 LCD
4 Menu Back button
5 Menu Up button, Menu Down button
6 Menu Enter button
7 ON LINE switch
8 CANCEL switch
The buttons are used to operate the
printer; the LEDs and LCD display the
status of the printer.
Print a Demo Page
1 Press the ENTER button on your printer
to display
INFORMATION MENU on the
LCD.
2 Press ENTER to select the menu.
3 Press the DOWN ARROW until DEMO1 is
displayed on the LCD.
4 Press ENTER to print the demo page.
Print the Menu Map
The Menu Map prints a list of all the
printer's menus and their current
settings.
1 Press the ENTER button on your printer
to display
INFORMATION MENU on the
LCD.
2 Press ENTER to select the menu.
3 PRINT MENU MAP is displayed on the
LCD; press
ENTER to print the menu
map.
Computer Connection
Install Network Cable
1 Turn the printer OFF.
2 Locate the LAN port (A). Remove the
plastic cap.
3 Connect the Ethernet cable between
the printer and the Ethernet hub or
router.
USB Connection
NOTE: Windows USB—Install the printer
software BEFORE installing the USB cable. See
“Install the Driver” on page 9.
NOTE: Printer operation is not assured if another
USB compatible device is connected concurrently
with it.
Connect the USB Cable
1 Turn the printer OFF.
2 Connect the USB cable to the USB port
on the computer, then to the USB port
on the printer (A).
C M Y K
1
A
A

Oki C3600n Specifications

General

Brand	Oki
Model	C3600n
Category	Printer
Language	English