Replacing consumable items > 69
F
USER
REPLACEMENT
The fuser is located inside the printer just behind the four image
drum units.
Switch off the printer and allow the fuser to cool for about
10 minutes before opening the cover.
1. Press the cover release and open the printer’s top cover
fully.
2. Identify the fuser handle (1) on the top of the fuser unit.
3. Pull the two fuser retaining levers (2) towards the front of
the printer so that they are fully upright.
WARNING!
If the printer has recently been powered on, some
fuser components will be very hot. Handle the fuser
with extreme care, holding it only by its handle, which
will only be mildly warm to the touch. A warning label
clearly indicates the area. If in doubt, switch the
printer off and wait at least 10 minutes for the fuser
to cool before opening the printer cover.
C
M
Y
K
1
2
To Next Page
Loading...
Need help?
General
