Installing upgrades > 74
M
EMORY
UPGRADE
The basic printer model comes equipped with 256MB of main
memory. This can be upgraded with an additional memory board
of 256MB or 512MB, giving a maximum total memory capacity of
768MB.
Installation takes a few minutes, and requires a medium size
cross-head (Philips type) screwdriver.
1. Switch the printer off and disconnect the AC power cable.
2. Press the cover release and open the printer’s top cover
fully.
3. Lift the front cover latch and pull open the front cover.
WARNING!
If the printer has been powered on recently, the fuser
will be hot. This area is clearly labelled. Do not touch.
To Next Page
Loading...
Need help?
General
