76 – C610/C711 User’s Guide
• To remove a sheet from the central area of the belt (b),
carefully separate the sheet from the belt surface and
withdraw the sheet.
• To remove a sheet just entering the fuser (c), separate the
trailing edge of the sheet from the belt, push the fuser
pressure release lever
(d) towards the front and down to
release the fuser’s grip on the sheet, and withdraw the
sheet through the drum cavity area. Then allow the
pressure release lever to rise again.
Note:
If the sheet is well advanced into the fuser (only a short
length is still visible), do not attempt to pull it back.
d
To Next Page
Loading...
Need help?
General
