Microsoft Windows > 46
Using TCP/IP protocol
When using lpr in UNIX and other TCP/IP environments,
please select Yes. To use in a TCP/IP environment, an IP
address should be assigned to the Ethernet card.
If Yes has been selected and TCP/IP is the only working
protocol and the IP address has not already been assigned,
you can either obtain an IP address automatically or assign
an IP address.
When Obtain an IP address automatically is selected,
the device IP address will be automatically assigned by the
DHCP server. In an environment without a DHCP server,
please assign the IP address manually.
If you are manually assigning an IP address, you need to
enter:
> An IP address
> Subnet mask
> Gateway address.
9. Click Next.
Using Bonjour protocol
Bonjour is the preferred protocol for printing data from the
Macintosh environment.
Using NetBEUI protocol
Using NetBEUI makes it easy to manage your Oki product
and print within the network environment of Windows.
10. When the settings are correct, click Execute. The new
settings are transmitted to the network card but it still
operates with pre-transmission settings.
11. Click Finish to validate the new settings.
12. Switch the printer off for 15 seconds and on again.
Now that both Windows and the printer have been configured to
use TCP/IP, the next step is to configure Windows to print to the
network printer.
To Next Page
Loading...
Need help?
General
