Microsoft Windows > 47
N
ET
BEUI P
ROTOCOL
N
ETWORK
P
RINTER
S
ETTINGS
There are two configurable items under NetBEUI within the
printer. These can be configured using the standard set-up utility
described in “Device setup” on page 13.
Although there are some differences in configuration options
between the various Windows platforms, the procedure for
printing using NetBEUI is the same.
Please ensure the NetBEUI protocol has been installed in
Windows. This can be confirmed by checking the network
settings. If NetBEUI has not been installed please refer to the
section below.
The relevant Windows installation CD-ROM may be required and
you should follow the on-screen dialogue box prompts.
W
INDOWS
XP
Although you can install the NetBEUI protocol into Windows XP,
it may not be supported. You should be able to use NetBEUI on
LAN connections although you will not be able to use this on a
Remote Access Service Connections.
1. In the Start menu, select Settings then Control Panel.
2. Double-click on Network Connections.
3. Right-click the adapter you wish to add NetBEUI to and
then click Properties.
4. On the General tab, select Install.
5. Select Protocol and then Add.
COMPUTER NAME NAME ASSIGNED TO THE PRINTER
Workgroup
PrintServer
1
1. Although the workgroup name can be changed, it is recommended
that it remains as PrintServer.
Comment User definable description
To Next Page
Loading...
Need help?
General
