12 Configuration: Ad Hoc Mode
C
ONFIGURATION
: A
D
H
OC
M
ODE
IP ADDRESS _______________________
For the Wireless Card
The IP Address for the wireless card is set automatically. It
appears on the wireless card Network Summary printout (see
page 4) under TCP/IP Configuration.
To set the IP Address manually, use the printer menu:
1. With
Ready to Print
on the display, press ENTER to switch to the
Menu Mode.
2. Use the ∇ and ∆ buttons to scroll to [Admin Setup]. Press
E
NTER.
3. Use the ∇, ∆ and E
NTER buttons to enter your 4-digit
password (default is 0000). Press E
NTER.
4. Use the ∇, ∆ and ENTER buttons to scroll to
[Network Setup] → [Slot2:Wireless] → [IP Address Set],
then select [Manual]. Press E
NTER.
5. Use the ∇, ∆ and ENTER buttons to enter the IP Address.
Press E
NTER.
6. Press BACK.
7. Use the ∇ and ∆ buttons to scroll to [Subnet Mask], then use
the ∇ and ∆ buttons to set the Subnet Mask values. Press
E
NTER.
NOTE
These instructions assume the following:
• You have connected the printer’s built-in print server.
• You have configured both the printer’s and computer’s
IP Address, Subnet Mask and Default Gateway.
To Next Page
Loading...
Need help?
General
