C9600 User’s Guide> 31
the face-up paper stacker. This ensures that the paper path through
the printer is almost straight.
The multi-purpose tray can feed paper widths as small as 76.2mm
and lengths up to 1200mm. For banner printing, recommended
sizes are A4 wide, 900mm and 1200mm long and weight 128g/m².
Since paper of width less than 100mm does not autofeed, you have
to press the ONLINE button to cause it to feed.
Use the multi purpose tray for printing on envelopes and
transparencies. Up to 100 sheets of transparencies or 25 envelopes
can be loaded at one time, subject to a maximum stacking depth of
25mm.
Paper or transparencies should be loaded print side up and top edge
into the printer. Do not use the duplex (two-sided printing) function
for transparencies.
F
ACE
-
DOWN
STACKER
The face-down stacker on the top of the printer can hold up to 500
sheets of 80g/m² standard paper, and can handle paper stocks
from 64 – 216g/m². Pages printed in reading order (page 1 first)
will be sorted in reading order (last page on top, facing down).
F
ACE
-
UP
STACKER
The face-up stacker should be opened and the tray extension pulled
out when required for use. (With the face-up stacker either open or
closed, the driver setting of Face Down will successfully direct prints
to the Face-Down stacker.)
The face-up stacker can hold up to 250 sheets of 80g/m² standard
paper and can handle stocks up to 268g/m².
Always use this stacker and the multi-purpose feeder for paper
stocks heavier than 216g/m².
D
UPLEX
UNIT
(
IF
INSTALLED
)
This unit provides automatic two-sided printing on plain paper fed
from Trays 1 – 5 or the MP Tray. Applicable paper sizes are A6, A5,
B5, B5LEF, Executive, A4, A4LEF, Letter, LetterLEF, Legal 13 in,
Legal 13.5 in, Legal 14 in, B4, Tabloid, Tabloid Extra, A3, A3 Wide,
A3 Nobi, Custom size (100 – 328mm wide, 148 – 457.2mm long),
using paper stocks in the range 64 – 120g/m².
To Next Page
Loading...
Need help?
General
