Oki C9600hdtn User Manual (English)

Other manuals for Oki C9600hdtn

User Guide130 pages

Printing Guide111 pages

Questions and Answers:

B
Barbara FullerAug 27, 2025
What to do if Oki Printer is not identified by the Chooser and the Setup Utility?
- K
  Katie BarnettAug 27, 2025
  If your Oki Printer is not identified by the Chooser and the Setup Utility, here are a few steps you can take: * Turn the printer off and on again. * Make sure the network cable is correctly connected, and try changing the cable. * If the network resides in a Zone, ensure the correct Zone name is selected in the Chooser. * Verify that the Zone name in the utility related to the NIC is the same as the Zone name set in the NIC. * Ensure AppleTalk (or Network in some OS versions) is set to Enable at the bottom right of the Chooser. * Make sure Ethernet is selected in AppleTalk (or Network). * Confirm the print driver is selected in the Chooser. * Ensure the EtherTalk protocol is set to Enable. * Print the NIC settings and confirm that the EtherTalk Port name is not blank.
M
mbirdAug 26, 2025
How to fix Oki Printer cannot find the network interface card?
- M
  Madison GillAug 26, 2025
  To resolve the issue of your Oki Printer not being able to find the network interface card, try the following: * Turn the printer off and on again. * Confirm that the network interface is enabled on the printer. * Ensure there is a response to the interface card command. * Make sure the network cable is correctly connected; change the cable and try again if needed. * Run the Self-diagnostic test (with the printer on, press and hold the Test button on the print server for 3 seconds, then release it). * Verify that the IP Address, Subnet Mask, and Gateway are correct. * Ensure that the TCP/IP protocol is set to Enable. * Reset the network interface card to the factory default settings. * If DHCP, BOOTP, and RARP are not used, ensure they have been set to Disable.
M
meyertinaAug 25, 2025
What to do if I have connection problems for wireless devices with my Oki All in One Printer?
- T
  Troy AlexanderAug 26, 2025
  If you're experiencing connection issues between your Oki All in One Printer and wireless devices, there are several things to check. The issue might stem from the access point devices or the wireless computers themselves. Ensure you have the latest firmware for your access point devices and the latest drivers for your wireless computer. Also, the access point device may be set to “High-Speed Mode;” try disabling this setting. If MAC Address Filtering is enabled on your access point, register the wireless card’s MAC address in the MAC Address Filtering list. Finally, multiple access points might have the same SSID. Check the SSID of access point devices in the surrounding area, including floors above and below, and check for any unauthorized access points.
R
Rick WallAug 25, 2025
What causes repeated fine streaks on prints from my Oki C9600hdtn Printer?
- C
  Christopher MendozaAug 25, 2025
  Repeated fine streaks may appear if the wrong media type was selected in the printer driver. Ensure you set the correct media type in the printer driver.

Oki C9600hdtn Specifications

General

Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	150000 pages
Connectivity	Ethernet
Operating System Compatibility	Windows, macOS, Linux
Media Size	A4, A5, B5
Supported Media Types	Envelopes, labels, plain paper