To Next Page

To Previous Page

MB290

- 17 -

Installation

2 Push the lower panel down until it clicks.

3 Setup the back side feed cassette stop by pushing

the "PUSH" lever (A).

Then adjust the lateral paper guides to the paper

format by pushing lever (B) located on the left

guide. Adjust the length paper guide to the paper

format by pushing lever (C).

4 Take a paper stack, pull the paper off and align it

on a flat surface.

5 Put the paper stack in the feed cassette

(200 sheets of 80 g/m² paper for instance).

6 Put the feed cassette back in its location.

Cartridge installation

1 Stand in front of the machine.

2 Push the left and right sides of the cover and pull it

towards you at the same time.

3 Unpack the new cartridge. Gently roll the cartridge

5 or 6 times to distribute the toner evenly inside the

cartridge. Thoroughly rolling the cartridge will

assure the maximum copies per cartridge.

Hold it by its handle.

4 Insert the cartridge in its slot by pushing it until it

clicks (last move down) as shown on the picture

below.

5 Close the cover.

Other manuals for Oki MB290

Questions and Answers:

Need help?

Do you have a question about the Oki MB290 and is the answer not in the manual?

General