- 13 -
Installing Your Machine
1
Machine Setup
●● Installing Your Machine
This section explains how to unpack and install the machine.
Installation Requirements
This section explains the required environment
and space for machine installation.
Installation Environment
Your machine must be installed in the following
environment:
Temperature: 10°C~32°C
Humidity: 20%~80% RH (relative
humidity)
Maximum wet bulb
temperature: 25°C
Note
● Be careful of condensation. It may cause a malfunction.
● If installing your machine where the relative humidity of
the surrounding air is less than 30%, use a humidier or
antistatic mat.
WARNING
● Do not place in hot locations or near re.
● Do not install in locations where chemical
reactions take place (laboratory etc.).
● Do not place in locations near ammable solutions
such as alcohol and thinner.
● Do not place in locations within reach of small
children.
● Do not install in unstable locations (wobbly stand,
angled place, etc.).
● Do not install in locations with high humidity or
dust and where exposed to direct sunlight.
● Do not install in an environment exposed to briny
air and corrosive gas.
● Do not install in locationss with much vibration.
● Do not install in locations where the ventilation
holes of the machine are blocked.
CAUTION
● Do not place directly on a rug or carpet with long
strands.
● Do not install in a closed room with poor
ventilation or circulation.
● If you use the machine in a small room for a long
time, please make sure that you ventilate the
room.
● Install away from strong magnetic elds and
sources of noise.
● Install away from monitors or TVs.
● When moving the machine, hold it on both sides,
and move it by slightly tilting the back down.
Installation Space
Install your machine on a at surface that is
wide enough to accommodate the machine.
Allow for enough room around your machine
according to the images below.
● Top view
100cm
20cm
20cm
60cm
● Side view
60cm
To Next Page
Loading...
Need help?
General
Weight and Dimensions
