Appendix A - menu system > 171
Fax Setup
a
(cont.)
Other Settings
(cont.)
Ring Response 1 Ring
Enter the number of rings
required before receiving
an incoming fax.
Dialling Pause Duration 2 second(s) Enter the pause
duration required.
Range: 0 - 10
second(s)
Rx Reduc. Rate Auto Select the Rx
reduction rate.
Reduc. Margin 24 mm Select the reduction
margin.
Range: 1 - 100 mm
ECM Mode ON
Error correction mode
(ECM) automatically
detects and corrects
errors in the fax
transmission process that
are sometimes caused by
telephone line noise.
Prefix user defined Enter the require
dialing prefix (if you
are connected via a
PBX then you need to
enter a prefix to
obtain an outside line
connection).
Received Time Stamp OFF Set to ON if you want
the time stamp printed
on incoming faxes.
Print Check Message ON If enabled, when a
transmission error
occurs the error
content is reported.
Fax Setting Service Bit OFF
Country Code International Select the country in
which the MFP is
situated.
A/R Full Print ON
Tone For Echo
(For Transmission)
Disable
Tone For Echo
(For Reception)
Disable
H/Modem Rate (For Tx) 33.6 Kbps Specify modem rate.
H/Modem Rate (For Rx) 33.6 Kbps Specify modem rate.
Attenuator 0~15 dB Enter Attenuator.
It only shows, when
ServiceBit = ON.
MF Attenuator 0~15 dB Enter MF(Tone)
Attenuator.
It only shows, when
ServiceBit = ON.
ITEM OPTION DEFAULT VALUE/DESCRIPTION
To Next Page
Loading...
Need help?
General
