Troubleshooting > 41
The selected skip over
perforation spacing does
not match the physical
tear-off perforation
positions.
The paper length selected
in the application does not
match the physical paper
length.
Match the paper length
selected in the application
with the physical paper
length in use.
Select the paper length in
number of lines in the
application.
Abnormal switchover between cut sheet and continuous forms modes.
No cut sheet feed. The printer is in continuous
forms mode.
Set the Paper Type lever to
cut sheet mode.
No continuous forms feed. The printer is in cut sheet
mode.
Set the Paper Type lever to
continuous forms mode.
Paper feed operations for
both cut sheets and
continuous forms are
actuated.
The cut sheet is not
ejected.
Eject the cut sheet.
PROBLEM CAUSE ACTION
To Next Page
Loading...
