MPS9650c User’s Guide> 65
T
ROUBLESHOOTING
G
ENERAL
If the printer display panel does not display anything or is still in
stand-by mode 10 minutes after switching on, follow the printer
shutdown sequence to switch it off. Check all cable connections
before restarting the printer. If the problem persists, contact your
dealer.
P
APER
J
AMS
This section provides information to help you deal with problems
that may arise when using the printer. The following paragraphs
describe actions to take in the event of a paper jam and how to deal
with unsatisfactory print results. Display panel messages about
paper jams and relevant actions are given in this section while a list
of other typical messages and suggested responses is given in
“Appendix A – Display Panel Messages” on page 105.
P
APER
JAMS
–
PRINTER
If a paper jam occurs, a message appears on the display panel in the
printer Control Panel. You can press the Help button to display
guidance on how to clear the jam.
For full details of clearing jams, refer to the following paragraphs,
which correspond to the paper jam messages.
O
PEN
COVER
,
PAPER
JAM
,
TTTTTT
SIDE
COVER
Tray 1, or any one of Tray 2 to Tray 5 (if installed), can appear in
place of the tttttt characters in the display panel message. In this
example Tray 1 is used, the procedure being similar for all other
trays.
To Next Page
Loading...
Need help?
General
