(1) in case of "Up" fault : 3 "gas" alarms and fault alarm are triggered.
(2) In case of "Up" fault : only the fault alarm is triggered.
This key can also be used to exit from the current menu.
When in a menu, you can go back (to make checks or modifications,
etc.) by pressing and holding Programming key and by successively
pressing and releasing the down key
.
[ ]
Parameters specified in square brackets [ ] are the VALID parameters
(in memory).
(1) Free This means that the relay can be activated when programming alarm
thresholds are triggered.
Set to 0
This means that the relay is not powered supply, and will not be
activated by MX48 control unit with alarm..
Set to 1 This means that the relay is always powered supply (by the MX48
control unit), and neither will not be activated by MX48 control unit
with alarm. Using of relays will be directly programmed by J-BUS
input and "COM52" software.
To Next Page
Loading...
