Be sure to keep your original hand-held transmitter in
case you need to erase and reprogram the universal
transmitter.
Note to
Canadian
Owners:
During programming, your
hand-held transmitter may stop transmitting after one or
two seconds. If you are programming from one of these
transmitters, you should press and repress the button on
the hand-held transmitter every two seconds without
ever releasing the button on the universal transmitter.
Release both buttons when the red light on the universal
transmitter begins to flash rapidly.
Operating
the
Transmitter
Press the appropriate button on the universal transmitter.
The red light comes on while the signal is being
transmitted.
Note that the effective transmission range of the
universal transmitter may differ from your hand-held
transmitter and from one channel to another.
Erasing
Channels
To
erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Accessories
Accessories for your universal transmitter are available
from the manufacturer of the unit. If you would like
additional information please call 1-800-355-35 15.
To Next Page
Loading...
Need help?
General
