44
How
to
Add
Fluid
Refer to the Maintenance Schedule to determine what
kind of transaxle fluid to use. See “Recommended
Fluids and Lubricants” in the Index.
If the fluid level is low, add only enough of the proper
fluid to bring the level into the cross-hatched area on
the dipstick.
1.
L.
3.
Check both sides of the dipstick, and read the
lower level. The fluid level must be in the
cross-hatched area.
4.
If the fluid level is in the acceptable range, push the
dipstick back in all the way.
0
0
Pull out the dipstick.
Using a long-neck funnel, add enough fluid at the
dipstick hole to bring it to the proper level. It doesn’t
take much fluid, generally less than a pint
(0.5
L).
Don’t
overfill.
We recommend you use only fluid
labeled DEXRON@-111, because fluid with that
label is made especially for your automatic transaxle.
Damage caused by fluid other than DEXRON@-I11
is
not covered by your new vehicle warranty.
After adding fluid, recheck the fluid level as
described under
“How
to Check.”
When
the
correct fluid level
is
obtained, push the
dipstick back in all the way.
To Next Page
Loading...
Need help?
General
