m
m.
.pse
When the ignition
is
on, the Driver Information Center
can be used as a stopwatch. The display will show hours
and minutes. The elapsed time indicator will record up
to 100 hours, then it will reset to zero and continue
counting. Press ET, and the display will show the
amount
of
time that has elapsed since the elapsed time
indicator was last reset (not including time the ignition
is
off),
such as:
01:08
ELAPSED TIME
To reset elapsed time to zero, press RESET while the
elapsed time
is displayed.
Press DATE to display the date.
To
change the date,
press DATE then RESET. The following display will
appear:
MONTH? XX/DD/YY
MM,
DD
and YY represent the month, date and year
you
currently have in your system. Check to make sure
your clock
is
in the correct AM or
PM
mode.
Notice that each key has a number. Push the key to enter
the number. The first XX’s will flash until you enter the
first digit for the month. You don’t need to enter the
leading zero if the number is under
10.
Press ENTER
after you’ve entered the month. The display will
change to:
DAY? MM/XX/YY
Set the day just as you set the month. After the day entry
is made, press ENTER, and the display will change to:
YEAR? MM/DD/XX
Set the year just as you set the month and day.
If
a valid
date
is
entered, the display will automatically exit to the
date mode and display the day
of
the week, the month
and the date. If an invalid date is entered, the display
will return to MONTH? XX/DD/YY and you’ll need to
repeat the above steps.
After a battery reconnect (loss
of
power), the display
will read CONFIRM TIME AND DATE.
?-79
To Next Page
Loading...
Need help?
General
