11
up
l1lC
You may override the automatic airflow distribution by
rotating the AUTO-PUSH knob. After you rotate this
knob, the comfort setting will be displayed for five
seconds then the outside temperature will be displayed.
The fan control will remain in the automatic control
mode unless you rotate the AUTO FAN knob to select a
manual fan speed.
@*
fl
Upper:
Directs airflow through the upper air
outlets located in the instrument panel and door panels.
fl
Bi-Level:
Directs the airflow through both the
upper air outlets and the lower floor outlets. There is
also a small amount
of
air directed to the front defroster
and the side window defrosters.
$/
Heat:
Directs most
of
the airflow to the lower
floor outlets with some airflow directed to the side
window defrosters. There is also a small amount of
airflow directed to the front defroster.
eo
@?
'
/
Defog:
Directs the majority of the airflow to the
lower floor outlets and the front defroster. A small
amount of airflow is directed
to
the side window
defroster outlets. This mode can be useful to remove the
moisture from the inside
of
the windshield when the
outside temperature is cold or the humidity is high.
DEF (Defrost):
Directs the majority
of
the airflow
to the windshield with some airflow to the side window
defrosters and lower floor outlets. To increase the fan
speed, rotate the AUTO FAN knob to the right.
RECIRC:
Press this button to limit the amount of
outside air entering your vehicle. This is helpful when
you are trying to cool the interior of the vehicle quickly
or limit the amount of outside air entering your vehicle
for some other reason. The RECIRC button and the
AUTO-PUSH knob may be selected at the same time.
The system will remain in RECIRC
for
12
minutes or
until the ignition is turned off, then the system will
return back
to
the previously selected mode. RECIRC
may be selected in all manual airflow modes except
FRONT Defrost.
To Next Page
Loading...
Need help?
General
