RCL:
Press
this
button briefly to recall the station'being
played. or to display the clock. To change what is
normally shown on the display (station or time), press
the RCL buttonuntil you see the display you want, then
hold the RCL button until the display flashes.
If
you
press the button when the ignition is
off,
the clock will
show for a few seconds.
g
a
Station
AM-FM:
Press this button to get
AM,
FM1
or
FM2.
The display shows your selection.
TUNE:
.Press this
knob
lightly
so
it extends. Turn it. to
choose radio stations. Push the knob back in when
you're not
using
it.
SEEK:.l?ress the up or 'down arrow to go to the
next higher
or
lower station. 'The
sound
will
be muted
while seeking.
SCAN:
Press this button and release
it
to listen to
stations for a few seconds.
The
radio will
go
to
a
station,
stop for a few seconds, then go on to the next station.
Press
the button again to stop scanning. The sound will
be muted while scanning, and SCAN will appear on the
display.
If
you press SCAN
for
more than two seconds,
the radio will change to PSCAN mode. PSCAN will
appear on the display.
1
PSCAN:
Press SCAN for more than two seconds, and
PSCAN will appear on the display. The radio will go to
the first preset station stored on your pushbuttons, stop
for a few seconds, then go on to the next preset station.
Press SCAN again to stop scanning.
PUSHBUTTONS:
The five numbered pushbuttons
let
you return to your favorite stations.
You
can set up to
15
stations (five
AM,
five
FMl
and five FM2).
1.
2.
3.
4.
5.
Press AM-FM to. select the band.
Find the station you want by using
TUNE
or
SEEK.
Press
TONE
to select the graph that best suits the
type of station selected.
Press
and
hold one of the five numbered buttons.
The sound will mute. When
it returns, release the
button. Whenever you press that numbered button,
the station you set wili return and the
TONE
equalization that you selected will
also
be
automatically selected for that button.
Lf
you
manually
tune
or use SEEK or
SCAN
to
find
a
frequency stored
in
a preset, the
TONE
equalization stored
for that frequency will not
be
recalled. Always check the
display first to make sure you have the correct band.
3-18
To Next Page
Loading...
