A
B
If
you’re using a weight-carrying hitch, the trailer
tongue (A) should weigh
10%
of the total loaded trailer
weight
(B).
If
you have a weight-distributing hitch, the
trailer tongue (A) should weigh
12%
of the total loaded
trailer weight
(B).
After you’ve loaded your trailer, weigh the trailer and
then the tongue, separately, to see if the weights are
proper. If they aren’t, you may be able to get them right
simply by moving some items around in the trailer.
-
.&l
T”-!ight
un
Iuur
Vehicle’s
1
Be sure your vehicle’s tires are inflated to the
recommended pressure for cold tires. You’ll find these
numbers on the Certification label at the rear edge
of the
driver’s door or see “Loading Your Vehicle” in the
Index. Then be sure you don’t go over the
GVW
limit
for your vehicle, including the weight of the trailer
tongue.
It’s important to have the correct hitch equipment.
Crosswinds, large trucks going by and rough roads are a
few reasons why you’ll need the right hitch. Here are
some rules to follow:
0
0
Will you have to make any holes in the body of your
vehicle when you install a trailer hitch?
If
you do,
then be sure
to
seal the holes later when you remove
the hitch. If you don’t seal them, deadly carbon
monoxide
(CO)
from your exhaust can get into your
vehicle (see “Carbon Monoxide” in the Index). Dirt
and water can, too.
The bumpers on your vehicle are not intended
for hitches.
Do
not attach rental hitches or other
bumper-type hitches
to
them. Use only a
frame-mounted hitch that does not attach to
*
:
bumper.
To Next Page
Loading...
Need help?
General
