Open the cap labeled
WASHER
FLUID
ONLY.
Add
washer fluid until the tank is full.
NOTICE:
When using concentrated washer fluid,
follow the manufacturer’s instructions for
adding water.
Don’t mix water with ready-to-use washer
fluid. Water can cause the solution to freeze
and damage your washer fluid tank and
other parts of the washer system. Also,
water doesn’t clean
as
well
as
washer fluid.
Fill your washer fluid tank only
3/4
full
when it’s very cold. This allows for
expansion, which could damage the tank if
it is completely full.
windshield washer. It can damage your
washer system and paint.
Don’t use radiator antifreeze in your
Brake-
Brake
Flr
-’
Your brake master cylinder reservoir is here. It
is
filled
with DOT-3 brake fluid.
There are only two reasor
why
the brake fluid level in
the reservoir might go down. The first is that the brake
fluid goes down to an acceptable level during normal
brake lining wear. When new linings are put in, the fluid
level goes back up. The other reason is that fluid
is
leaking out of the brake system. If it is,
you
should have
To Next Page
Loading...
Need help?
General
