If
you accidentally use a key that has
a
damaged or
missing
resistor pellet, the starter won’t work and
the
SECUFUTY light will flash
and
the CLEAN
KEY..
WAIT
3 MINUTES message will appear.
See your Aurora retailer
or
a locksmith who can service
the PASS-Key
11
to have a new key made.
If
you’re ever driving and the SECURITY light comes
on
or PASS-KEY SYSTEM FAULT appears, you will
be able to restart your engine
if
you turn it off. Your
PASS-Key
I1
system, however, is not working properly
and
must be serviced by your Aurora retailer. Your
vehicle is not protected by the PASS-Key
I1
system.
If
you lose or damage a PASS-Key
I1
ignition key, see
your Aurora retailer or
a
locksmith who
can
service
PASS-Key
I1
to have a new key made.
New
Vehicle
“Break-In”
NOTICE:
Your modern Aurora doesn’t need an elaborate
“break-in.” But it will perform better in the long
run if you follow these guidelines:
e
Don’t drive
at
any one speed
--
fast or
slow
--
for
the first
500
miles
(804
km).
Don’t make full-throttle starts.
200 miles
(322
km)
or
so.
During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every
time you get new brake linings.
See “Towing
a
Trailer’’ in the Index for
more information.
Avoid making hard stops for the first
Don’t tow
a
trailer during break-in.
To Next Page
Loading...
Need help?
General
