This device complies with Part
15
of the FCC Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference,
and
(2)
this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with
RSS-210
of
Industry Canada.
Operation is subject to the following two conditions:
(1)
this device may not cause interference, and
(2)
this
device must accept any interference, including
interference that may cause undesired operation
of
the device.
Changes and modifications to this system by other than
an authorized service facility could void authorization
to
use this equipment.
Programming the Transmitter
Do
not use
the
universal transmitter with any garage
door opener that does not have the “stop and reverse”
safety feature. This includes any garage door opener
model manufactured before April
1,
1982.
rse
sure that people and objects are clear of the garage
door you are programming.
Your vehicle’s engine should be turned off while
programming your transmitter. Follow these steps to
program up to three channels:
1. If you have previously programmed a universal
transmitter channel, proceed to Step
2.
Otherwise,
hold down the two outside buttons on the universal
transmitter until the red light begins to flash rapidly
(approximately
20
seconds). Then release the
buttons. This procedure initializes the memory and
erases any previous settings for all three channels.
2.
Hold the end of your hand-held transmitter against
the bottom surface of the universal transmitter
so
that you can still see the red light.
3.
Decide which one of the three channels you want to
program. Using both hands, press the hand-held
transmitter button and the desired button on the
universal transmitter. Continue to hold both buttons
through Step
4.
4.
Hold down both buttons until you see the red light
on the universal transmitter flash slowly then
rapidly. The rapid flashing, which could take up
to
90
seconds, indicates that the universal transmitter
has been programmed. Release both buttons
three seconds after the light starts to flash rapidly.
2-57
To Next Page
Loading...
Need help?
General
