If
you have trouble programming the universal
transmitter, make sure that you have followed the
directions exactly as described and that the batteries
in the hand-held transmitter are not dead. If
you
still
cannot program it, rotate your hand-held transmitter
end over end and try again. The universal transmitter
may not work with older garage door openers that do
not meet current Federal Consumer Safety Standards.
If
you cannot program the transmitter after repeated
attempts, consult your Aurora retailer.
Be sure to keep your original hand-held transmitter
in case you need to erase and reprogram the
universal transmitter.
Note
to
Canadian Owners:
During programming, your
hand-held transmitter may stop transmitting after one or
two seconds. If you are programming from one of these
transmitters,
you
should press and re-press the button on
the hand-held transmitter every two seconds without
ever releasing the button on the universal transmitter.
Release both buttons three seconds after the red light on
the universal transmitter begins to flash rapidly.
Operating the Transmitter
Press and hold the appropriate button on the universal
transmitter. The red light comes on while the signal is
being transmitted.
Note that the effective transmission range of the
universal transmitter may differ from your hand-held
transmitter and
also
from one channel to another.
Training a Garage Door Opener Equipped
with “Rolling Codes”
If
you programmed the universal transmitter, but the
garage door will not open, and
if
your garage door
opener was manufactured after
1995,
your garage
door may have a security feature that changes the
“code” of your garage door opener every time it is
opened or closed.
To
determine if your garage door opener has this rolling
code feature, press and hold the appropriate button on
the universal transmitter that was programmed. If the
red light flashes rapidly for one
to
two seconds, then
turns solid, your garage door opener has this feature.
To Next Page
Loading...
Need help?
General
