To
program a garage door opener with the rolling code
feature, do the following:
1.
2.
3.
4.
5.
Program your hand-held transmitter to the universal
transmitter by following the steps provided under
“Programming the Transmitter” earlier.
Locate the training button on the garage door opener
receiver. The exact location and color will vary
among brands. Refer to your garage door opener
manufacturer’s owner’s manual to locate the training
button.
Press the training button
on
the garage door opener
receiver for one to two seconds.
Return to your vehicle and press the programmed
button on the universal transmitter until the red light
flashes rapidly (about two seconds).
Release the button, then press it again to confirm it
was programmed
to
the garage door opener receiver.
You may
now
use either the universal transmitter or the
hand-held transmitter to open your garage door.
If
you
still have difficulty in programming and require
assistance, please call your retailer.
Erasing Channels
To
erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Accessories
Accessories for your universal transmitter are available
from the manufacturer of the unit.
If
you
would like
additional information please call
1-800-355-35
15.
2-59
To Next Page
Loading...
Need help?
General
