Check Oil Level Warning
When CHECK OIL LEVEL appears, it indicates that the
engine oil level is 1 to
1
1/2 quarts
(0.9
L to
1.4
L) low.
The message will appear only if the engine is running
and it’s been at least eight minutes since the engine was
last running. If the message appears, check the oil
dipstick level. If it reads low, your oil level should be
brought up to the proper level (see “Engine Oil” in the
Index). After bringing the oil to the proper level, the
ignition must be off for eight minutes to allow the
majority
of
oil to drain into the oil pan.
Distance to Destination
This feature acts as a reverse trip odometer by counting
backward from an estimated distance which you enter
before starting your trip.
It
also uses that information to
determine the estimated time of arrival.
To set, press DEST, then
RESET
and enter a maximum
of four digits for the length
of
your trip. (Always use
whole miles or kilometers.) Then press ENTER. The
system will only accept the last four digits you enter
as your distance to destination.
The system will display the total distance to destination,
such as:
365
MI
TO
DEST
or
587
KM TO DEST
When
the
system counts down to zero distance
remaining, even
if
you’re in another display, a chime
will sound and the display will show:
TRIP COMPLETE
The TRIP COMPLETE message will go off when you
press any button, or when you turn your ignition to
OFF,
then on. The display returns to the mode displayed prior
to the interruption.
Estimated Time
of
Arrival (ETA)
ETA is based on the average speed, the date and time
of
the day, and the estimated distance to your destination.
After you have entered your distance to destination,
press ETA to display estimated time
of
arrival, such as:
ETA TUE
12%
PM
Press ETA again to display the time to destination. The
display will show the current time
as
the hours and
minutes to destination, such as:
1250 TIME
TO
DEST
If the time to destination calculation is seven days or
greater, the display will read:
TRIP OVER
7
DAYS
To Next Page
Loading...
