When the trip
is
complete a chime will sound and the
display will show:
TRIP
COMPLETE
The trip complete message will
go
off when you
press any button,
or
when you turn your ignition off,
then on. The display returns to the mode displayed
prior to the interruption.
Elapsed Time
(ET)
When the ignition is on, the DIC can be used as a
stopwatch. The display will show hours and minutes.
The elapsed time indicator will record up to
100
hours,
then it will reset to zero and continue counting. Press
ET,
and the display will show the amount of time that
has elapsed since the elapsed time indicator was last
reset (not including time the ignition is off), such
as:
01:OS
ELAPSED TIME
To
reset elapsed time to zero, press RESET while the
elapsed time
is
displayed.
Date
Press DATE to display the date.
To
change the date,
press DATE then RESET. The following display
will appear:
MONTH? XX/DD/YY
MM,
DD
and YY represent the month, date and year
you currently have
in
your system. Check to make sure
your clock is in the correct AM or PM mode.
Notice that each key has a number. Push the key
to
enter the number. The first
XX’s
will flash until you
enter the first digit for the month. You don’t need to
enter the leading zero
if
the number is under
10.
Press
ENTER after you’ve entered the month. The display
will change to:
DAY? MM/XX/YY
Set the day just
as
you set the month. After the day entry
is
made, press ENTER and the display will change to:
YEAR? MM/DD/XX
2-80
To Next Page
Loading...
Need help?
General
