High-Beam Headlamp Bulbs
If
you need to replace a high-beam headlamp bulb, do
the following:
1.
Remove the headlamp assembly
if
you need more
hand clearance.
2.
Pull up on the wiring harness. This unlocks the bulb.
1.
4.
To
replace the bulb, angle the new bulb into the
empty socket.
5.
Push the base
of
the bulb down to lock it into place.
6.
If
you removed the headlamp assembly, reassemble
it by aligning the pin and tightening the two bolts
to
secure it.
Front Turn Signal
The turn signal bulb
is
on the inboard edge
of
the
headlamp assembly.
To
replace a bulb,
do
the following:
2.
3.
4.
3.
Now
you
can reach in behind the lamp housing and
pull out the bulb.
Remove the headlamp assembly
if
you need more
hand clearance.
Reach in and press the locking tab while twisting the
bulb assembly one-quarter
of
a
turn to the left
(counterclockwise).
Replace the bulb and reverse Step
2
to reassemble.
If
you removed the headlamp assembly, reassemble
it by aligning the pin and tightening
the
two bolts
to
secure it.
6-35
To Next Page
Loading...
Need help?
General
