Customizing
Your
Automatic
Door
Locks
Feature
You can program the automatic door locks feature to
change to the following modes:
Mode Operation
0
No automatic door lock or unlock.
1
All doors automatically lock when shifted
out of PARK (P).
No
automatic door unlock.
2
3
All doors automatically lock when shifted
out of PARK
(P).
Only the driver’s door
automatically unlocks when shifted into
PARK (P).
All doors automatically lock when shifted
out of PARK
(P).
All doors automatically
unlock when shifted into PARK (P).
Vehicles are delivered programmed in Mode
3.
To change the modes:
1.
Close all doors and turn the ignition on. Keep all
2.
Press and hold the lock position on the driver’s
doors closed throughout this procedure.
power door lock switch through Step
4.
3.
Press the LOCK button on the remote lock control
transmitter. The automatic door locks will remain in
the current mode.
4.
Press the LOCK button on the transmitter again.
Each time the transmitter’s
LOCK
button
is
pressed,
the mode will advance by one, going from Mode
3
to
0
to
1,
etc.
NOTE: The door locks will cycle according
to
the
mode entered while customizing memory door locks.
(Mode
“0”
has no feedback.)
5.
Release the power door lock switch. The automatic door
locks will remain in the most recent mode selected.
6.
Turn the ignition to
OFF.
Delayed
Locking
This Personalization feature lets the driver delay the
actual locking of the vehicle. When the power door lock
switch is pressed with the key removed from the ignition
and the driver’s door open, a chime will sound three
times to signal that the lock delay mode
is
active. When
all doors have been closed, the doors will lock
automatically after five seconds. If any door
is
opened
before this, the five-second timer will reset itself once
all
the
doors have been closed again.
Pressing the door lock switch twice within two seconds
will override this feature.
2-6
To Next Page
Loading...
Need help?
General
