A
$&‘
v
(Fan):
Press the up or down arrow on the
fan button to override the automatic fan control and
increase or decrease the fan speed.
A
TEMP
v
(Temperature):
Press either arrow
on
the
TEMP
button once to display your current
temperature setting in the digital display. Press the up
or down arrow again to provide
a
warmer or cooler
temperature setting.
Climate Controls Personalization
If your vehicle is equipped with this feature, up to two
drivers are able to store and recall climate control
settings for the temperature, the fan speed and the
direction of the airflow.
Memory buttons
1
and
2
are located on the driver’s
door panel and correspond to the numbers
1
or
2
found
on
the back of each remote keyless entry transmitter.
To
store settings, do the following:
1.
Select
the
desired temperature, fan speed and
airflow mode. If desired, a separate temperature
setting may also be selected for the front seat
passenger. For information on how to do this, see
Automatic Climate Control System
on
page
3-23.
2.
Locate memory buttons
1
and
2
on the driver’s door
panel.
3.
Press the memory button on the door panel that
corresponds to the number on the back
of
the
transmitter you are programming, until you hear two
beeps. The beeps confirm that your selection has
been saved and can now be recalled. For more
information
on
the memory feature, see
Memory
Seat
and
Mkrors
on
page
2-48.
Follow these steps each time you want to change the
stored settings.
To recall the climate control settings last stored on your
transmitter, press the unlock button on your remote
keyless entry transmitter and put the ignition in
ACC (Accessory) or
ON. The settings will be recalled.
3-29
To Next Page
Loading...
