18
TV Installation and Connection Guide
Connecting to a Satellite Receiver or Cable Box with A/V Connectors
1.Using Audio and S Video cables, connect the satellite receiver's Audio
and S Video OUT jacks to the TV Audio and S Video IN jacks.
2.Connect a 75-ohm coaxial cable from your cable or antenna to the
Satellite Receiver's or Cable Box's Ant (Antenna) jack.
Note: When you connect video equipment to both the same Video and
S Video input jacks, display will automatically select S Video first.
To view S Video signal, please disconnect Video jack or turn off the
Video signal on the video equipment.
S-Video is strongly recommended for use if your VCR or video equipment
has it because S-Video input has better quality of picture than a composite
Video signal.
Disconnect all power sources before making any connections.
A/V cable with RCA connector
S VIDEO cable
Satellite Receiver or Cable Box
75-ohm coaxial cable
Rear of TV
To Next Page
Loading...
General