OligoMaker X12 - 7 Transportation; 8 Installation

!
!
! !
!
!
OligoMaker+DNA/RNA+Synthesizer+
OligoMaker+ApS!•!Kong!Georgs!Vej!12!•!DK-2000!Frederiksberg!•!Tel:!+45!321!322!00!!
www.oligomaker.com!•!email:!karl@ross.dk! !
p.13
Service holder position
7. Transportation
OligoMaker will be delivered to the customer on a pallet in a wooden box. Unpacking
must be done by professionals from OligoMaker ApS.
8. Installation
On site requirements: A ventilated hood or similar, connection to power (115 / 220
volts), and connection to Nitrogen (or Argon) bottle (at around 3 bar). A valve should be
nearby for possible shut down of gas.
1. Connect power supply 115 / 220 volts
2. Connect power supply from the Vacuum Pump to OligoMaker.
3. Connect Nitrogen (or Argon) to OligoMaker (tubing 6.0mm)
4. Connect OligoMaker to the pump (tubing 6.0mm)
5. Connect Vacuum Pump to waste container.
OligoMaker has a sound pressure level below 70db.