Olimpia splendid DOLCECLIMA COMPACT - 6 INCONVENIENCES and Possible REMEDIES

DOLCECLIMA COMPACT
ENGLISH
EN - 29
6 - INCONVENIENCES AND POSSIBLE REMEDIES
Do not try to repair the appliance by yourself.
Iftheproblemhasnotbeensolved,pleasecontactyourlocalretailerortheclosestassistanceservice.
Supplydetailedinformationaboutthemalfunctionandtheequipmentversion.
CAUSE
• Nopower.
• Theplughasnotbeeninserted.
• TimerisON
• Thetemperaturesetistoocloseto
ambient temperature.
• Suctionofoutsideairisobstructed.
• Windowopen.
• Somesourceofheatisoperatinginthe
room (burner, lamps, etc.) or the room
is crowded.
• Thetemperaturesetistoohigh.
• Thepoweroftheconditionerisnot
suitable for ambient conditions or
dimensions.
• Theconditionerhasbeentiltedorlaid
 at.
• Excessivebuild-up ofwater insidethe
conditioner
• Ambienttemperaturetoolow
WHAT DO I DO?
• Wait.
• Plugintheconditioner.
• Switcho󰀨thetimer
• Lowerthetemperatureset.
• Removetheobstructions.
• CalltheServiceCenter.
• Closethewindow.
• Eliminatesourcesofheat.
• Lowerthetemperatureset.
• Removetheplug(g.2ref.n°4)anddrain
the water before moving the conditioner.
• Pullouttheplug
• CalltheServiceCentre.
• Pullouttheplug
• CalltheServiceCentre.
• Pullouttheplug
• CalltheServiceCentre.
• Pullouttheplug
• Dainthewatercontainedbyremoving
theplug(g.2ref.n°4).Ifthisalarmis
displayed too frequently, call the Service
Centre.
• Airconditionerbehaviourisnormal.
MALFUNCTION
• Theconditionerdoesnotwork.
• Theconditionerworksonlyfora
short period.
• Theconditionerworksbutdoesnot
refresh the room.
• Waterleaksfromtheconditioner
during transport.
• Theconditionerswitcheso󰀨,thecontrols
on the remote control and the control
panel do not respond and alarm signal
“E1”ashesonthecontrolpaneldisplay.
• Theconditionerswitcheso󰀨,thecontrols
on the remote control and the control
panel do not respond and alarm signal
“E2”ashesonthecontrolpaneldisplay.
• Theconditionerswitcheso󰀨,thecontrols
on the remote control and the control
panel do not respond and alarm signal
“E4”ashesonthecontrolpaneldisplay.
• Theconditionerswitcheso󰀨,thecontrols
on the remote control and the control
panel do not respond and alarm signal
“P1”ashesonthecontrolpaneldisplay.
• Incooling,night-timeorautomaticmode,
minimum speed cannot be selected.