ENGLISH
EN - 32
4.2 - MAINTENANCE
If you do not intend to use the appliance for a long period of time, work as follows:
a.
Activate the fan only mode for a few hours (approximately 8÷10 hours) to dry the interior of the appliance.
b. Stop the air conditioner and disconnect the power supply.
c.
d. Completely discharge condensation.
e. Remove the batteries from the remote control.
Checks before resuming use of the air conditioner:
a.
b. Check that the air outlet or inlet are not obstructed (especially after a long period of inactivity of the air
conditioner).
4.2.a - Discharging condensation
When condensation in the lower tray reaches the predetermined level, the appliance emits beeps.
In this case:
a. Disconnect the plug from the power socket.
b. Carefully move the appliance in position suitable to unload water.
c. Remove the drain cap (24) (Fig.21).
d. If necessary, insert a pipe (8) in the connector.
d. Make water unload completely.
e. Re-position the drain cap (24) (Fig.22).
f. Insert the plug in the power socket.
If the error repeats, please contact an Assistance Centre.
To Next Page
Loading...
