797-32C BREAD SLICER
0797S20091 4-1
OPERATING INSTRUCTIONS
CAUTION
ALWAYS USE CARE WHENEVER WORKING NEAR THE CUTTING KNIVES.
Using the Slicer’s Holddown
These machines are equipped with a gravity style holddown which will self adjust to
product height. The holddown function is important because it will stabilize the product
during slicing.
Therefore, short products which do not contact the holddown may not slice well on this
machine. Products which are too tall to pass beneath the holddown must be
repositioned to allow passage. If they can not be repositioned to allow passage then the
product is outside the range that this machine can effectively slice.
Adjusting the Slicer for Product Length
Using a typical product, adjust the infeed chute side guides by applying hand pressure.
See the next illustration. Set the side guides approximately 1/8 inch wider than the
longest expected product.
To Next Page
