Adjusting the color tone (White balance)
Adjusting the image quality and exposure
4
78
5
Press to select one of the
white balance modes: AUTO, ,
, or , then press .
The white balance is set.
To close the menu, press again.
6
Take the picture.
• The white balance setting returns to AUTO (factory default setting)
when the lens barrier is closed. “Saving the settings (All Reset)”
( p.110)
• If you want a color tone that resembles what you see under tungsten
lighting, set the white balance mode to .
• White balance may not be effective under some special light sources.
• After setting a white balance mode other than AUTO, play back the
picture and check the colors on the monitor.
• When the flash is fired with a white balance setting other than AUTO,
colors may appear different in the resulting picture from the colors
you see on the monitor.
CARDSEt
CAM
PICtURE
AUtO
WB
To Next Page
Loading...
