Troubleshooting
163
10
Appendix
(When the camera is connected to a computer or printer
Possible cause Corrective action
Ref.
page
The printer fails to connect.
PC was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
Remove the USB cable, and start again from
Step 1 of “Connecting the camera to a
printer”.
P.123
The printer does not
support PictBridge.
Refer to the printer’s instruction manual or
contact the manufacturer.
–
The camera is not recognized by the computer.
The USB driver has not
been installed.
Install OLYMPUS Master. P.142
The camera has not
been turned on.
Set the mode dial to q, then press the
POWER switch to turn the camera on.
P.12
To Next Page
Loading...
