Function shooting (black & white/sepia)
74
5
More useful functions
2 Press the shutter button fully to take
the picture.
• Pressing the shutter button halfway locks
the focus and exposure.
• The self-timer/remote control lamp lights for
approximately 12 seconds, then starts
blinking. After blinking for approximately 2
seconds, the picture is taken.
• To stop shooting while in n mode, press
the shutter button fully again.
• To cancel the self-timer, press the Z
button.
• The self-timer mode is automatically canceled after one shot.
This feature lets you add a special black & white or sepia effect to your
pictures.
Top menu [MODE MENU] [CAMERA] [FUNCTION] [BLACK &
WHITE] / [SEPIA] / [OFF] g“Menus” (P.17)
Note
• If sequential shooting is attempted in self-timer mode, the camera shoots 5
frames at most regardless of the setting.
Note
• White balance, white balance compensation and saturation cannot be used
during function shooting.
Self-timer/
Remote control lamp
W
T
Function shooting (black & white/sepia)
Mode dial
To Next Page
Loading...
