119
Copying and pasting part of an image
1
Using the selection buttons in the tool bar, select the area you want to
copy from the image.
2
Click the Copy button.
This makes a copy of the selected area from the image, and places it in
the clipboard (temporary storage).
3
Click the Paste button.
The copied area appears in the center of the displayed image.
4
Drag the copied area to where you want to paste it.
Hold down the mouse button on the copied area while moving it, then
release the button when the copied area is in the correct position.
5
Click on any part of the image outside the pasted area.
This confirms the pasting position.
Undoing an operation
If an operation does not produce the desired effect, you can undo it, returning
the image to the previous state (for a maximum of 10 operations).
To undo an operation, click the Undo button.
Redoing an operation
Immediately after you have undone an operation, you can redo it (for a maximum
of 10 operations).
To redo an operation, click the Redo button.
• Use the Copy and Paste
combination to copy a part
of an image.
• You can also hold down the
Ctrl key (Windows), or hold
down the Option key
(Macintosh), and drag the
selected area for the same
effect.
• Once data is copied to the
clipboard, you can paste it
any number of times.
• If you then copy or cut
another selection to the
clipboard, this overwrites the
existing data.
To Next Page
Loading...