Olympus CK2 - 4 OPERATION; 1-1 Assembly and Operation of Each Component

4
OPERATION
* II the halogen bulb burnl out dJring operation, w.it until the
defective bulb and socket Ir. completely cooled before bulb reo
plac:em.nt to prltYlnl • burn.
21 lmen the OOnlaa pins' I completely into the socket 1, (Fig. 51
.. NeYel' use excessi .... force 10 twist or bend the bulb, but IIftltly
push in the pirn,
.. 00 not lea.... fingefl)rinu, 1WtC. on the mirror surfac. , . II
Rnudged, it should be wiped with gauu moinened with t smtll
tmount of t1cohol tnd~ ... 13:11 mixture. (Fig. 5)
3) Looking at the bulb from its froot direction, ascertain thilt the
lower- half of the iICl'"ew head 00 the mirror surface is coY8l"ed
by the filament. (Fig. 61
'* If the filtment devilles horizonttlly from the center of the screw
head, the bulb tilU to the right or left. Attach the bulb again
perpendiCl.llerly.
(FiG- 6)
'* If the filament devilles vertically, the contact pim tre not in-
serted
completely. Pu~ in the pins completely. (Fig. 6)
11 P\J1I 001 the contact pins of the halogen bulb lrem the polyethylene
....
Be certain not to love fingerprinu or smudge5 on tta bulb.
a Set 1in«.¥Cll Je1-aor_i
Set the line vollage "ector PNllch <D located al the base plate 01
the mjqO$COpe n¥ld 10 the loc:al line voltage IF'll 4 shows the
setting 01 the _itch at l00V),
fJ Inna
Hi
!1ll. the h,llOgl!!n ulb
,
_ .. For Ihe U.S.:
Frames sold in the U.S. meellhe UL standard end 8fe selat
115V. Therefor, Ihis selector switch is not included.
Fig 4 a
~
m
•
~
5
z
Fig 5
,
Polyethylene bag
~
Correct Deviated
(homonlally) (venically)
• - I Assembly and Operation of Each Component
Fig 6
,
II AttIC 1118 the bulb socbt
Aligning lhe guide pins <D to lhe guide holes <I> of the lamp houSing,
slowly insert
the bulb socket completely without tilling. (Fig 7)