DISASSEMBLING PROCEDURE CLV-160
3. Disassembling Procedure
1. Top cover
(1)
Turn the knobs, and remove the lamp
access cover.
(2)
Remove the screws on the rear panel.
Phillips screwdriver No.2 (HCBK3x6SA x 3)
(3)
Remove the screws from the side panel.
Phillips screwdriver No.2 (HCBK3x6SA x 10)
(4) Remove the top cover.
2. Front panel
(1)
Remove the screws that secure the front
panel to the chassis.
Phillips screwdriver No.2 (CCUK3x4SZ x 3)
(2)
Remove the harness from the main board.
(3)
Remove the cable from the sheet switch.
(A)
(4)
Remove the main board from the FP
chassis.
Phillips screwdriver No.2 (CCU3x6SZ x 4)
Tightens the capacitor.
5-2
To Next Page
Loading...
