Olympus CLV-160 - Page 40

DISASSEMBLING PROCEDURE CLV-160
5. NF board
(1) Remove the cable from the NF board.
(2) Remove the NF board from the power
supply unit.
Phillips screwdriver No.2 (CCUK3x6SZ x 5)
6. Power supply unit
(1) Remove the core, and remove the
emergency lamp housing from the power
supply unit.
(2) Remove the shield cover.
Phillips screwdriver No.2 (CCUK3x4SZ x 4)
(3) Remove the shield PS plate.
Phillips screwdriver No.2 (CCUK3x6SZ x 3)
(4) Remove the igniter harness from the
electrode.
Phillips screwdriver No.2
(CUKSK4x6SZ, CUKSK3x6SZ)
(5) Remove the cable from the power supply
unit from the pushbutton switch.
5-4