Olympus DS-9000 - Other Information; Device Care

53
5
EN
Device care
Other information
Device care
s Exterior
Wipe gently with a soft cloth. If the device is very
dirty, soak the cloth in mild soapy water and
wring well. Wipe the device with the damp cloth
and then wipe it with a dry cloth.
s Display
Wipe gently with a soft cloth.
Using alcohol disinfectant solution
NOTE
• Make sure that your device is turned OFF.
• Do not use other than ethanol for disinfection
(76.9 to 81.4 v/v%) and isopropanol for
disinfection (70 v/v%).
• The docking station cannot be cleaned with
alcohol disinfectant solution.
1 Soak a soft cloth in the disinfectant
solution and then wring the cloth to
prevent dripping.
2 Wipe the device gently.
3 Wipe the device well with a soft dry
cloth so that no solution remains.
f Caution
• Do not use disinfectant solution to clean
the LED and each sensor.
• Do not rub the device strongly when using
disinfectant solution. The paint or print
may peel off.
• Do not spray disinfectant solution directly
onto the device. The device does not have
a waterproof design so solution may enter
inside the device and affect the electronic
parts.