Olympus DS-9500 - Setting Time and Date [Time & Date]

14
1
EN
Setting time and date [Time & date]
If you set the time and date beforehand,
the information when the file is recorded is
automatically stored for each file. Setting the
time and date beforehand enables easier file
management.
When you use the recorder for the first time
after purchasing it, or when the battery
has been inserted without the device being
used for a long time, the [Set time & date]
will appear.
However, when a Password has been set
as the device lock function (☞ P.29), the
recorder will go to the time and date set
screen after verification (unlocking).
1 Press the 9 or 0 button to select
the item to set.
2 Press the + or − button to set.
• You can select the order of the “Month”,
“Day” and “Year” by pressing the F2 (M/D/Y)
button while setting them.
3 Press the OK/MENU button to complete
the setting.
• The clock will start from the set date and
time. Press the OK/MENU button according
to the time signal.
TIP
• Moving the slide switch to a position other than
STOP (4) while setting the time and date will
cancel the time and date setting. The recorder
will return to the previous time and date.
• You can set the time and date from your PC using
ODMS and DSS Player software (☞ P.46).
Setting time and date [Time & date]
OK/MENU button
+, − button
9 , 0 button
F1, F2, F3 button
Select the item from the
“hour”, “minute”, “month”,
“day” and “year” with a
flashing point.
You can select between
12 and 24 hour display
by pressing the F2 (24H)
button while setting the
hour and minute.