How to fix a blurry image on my Olympus Analytical Instruments?
If the image from your Olympus Analytical Instruments is not sharp, try wiping the objective lens on the insertion tube's distal end or the optical adapter with a clean piece of gauze or a cotton swab. Ensure the optical adapter is properly attached and that the external monitor is correctly adjusted.
Why is the operation load for articulation getting heavier on my Olympus Analytical Instruments?
If you are experiencing heavy operation load for articulation with your Olympus Analytical Instruments, the angulation lock might be engaged. Press down the [ANGLE LOCK] lever to release the angulation lock.
What to do if Olympus Analytical Instruments shows 'HIGH TEMPERATURE (MAIN UNIT)'?
If you see a 'HIGH TEMPERATURE (MAIN UNIT)' message on your Olympus Analytical Instruments, it indicates the main unit is overheating. Stop the inspection, allow the instrument to cool down, and then turn the power back on.
What to do if Olympus Analytical Instruments shows 'IMAGE CAPTURE ERROR'?
If you encounter an 'IMAGE CAPTURE ERROR' on your Olympus Analytical Instruments, stop the inspection and turn the instrument off, then turn it on again.
What to do if my Olympus Analytical Instruments shows 'RECORDING MEDIA FULL'?
To address a 'RECORDING MEDIA FULL' error on your Olympus Analytical Instruments, delete any unnecessary data from the USB flash drive to free up space. Alternatively, replace the current USB flash drive with a new one.
Why my Olympus Analytical Instruments system cannot be turned on?
If the system cannot be turned on, ensure the AC adapter or battery is correctly connected. Also, verify that you are pressing the power button on the main unit. If it still fails to turn on, check that you are using the designated AC adapter or battery for the Olympus Analytical Instruments.
What to do if I see a 'LOW BATTERY' message on my Olympus Analytical Instruments?
If you see a 'LOW BATTERY' message on your Olympus Analytical Instruments, immediately stop any image recording, copying, USB formatting, or deleting operations. Replace the battery or connect the AC adapter to continue using the instrument.
General| Brand | Olympus |
|---|---|
| Model | IPLEX RX Series |
| Category | Analytical Instruments |
| Language | English |
Describes the primary purpose and application of the instrument for inspection.
Provides guidance on safe and correct operation of the instrument.
Details required devices and compatible combinations for the product.
Outlines potential enhancements to the instrument's capabilities.
Explains signal words and symbols indicating hazards and important notes.
Covers essential safety rules and warnings for instrument handling and operation.
Identifies safety ratings and cautions located on the main unit.
Identifies safety ratings and cautions located on the control unit.
Lists all included items and instructions for checking contents upon receipt.
Describes the items stored within the optical adapter case.
Directs users to system chart for information on optional accessories.
Provides diagrams and labels for main and control unit components.
Covers initial steps including preparing the power supply (battery/AC adapter).
Guides users on how to view an object using the insertion tube and angulation controls.
Explains how to navigate and use the instrument's menu system.
Outlines the overall process for performing stereo measurements.
Explains when and how to replace the instrument's battery.
Lists common error messages, their causes, and recommended solutions.
Specifies the recommended environmental conditions for instrument operation.
Illustrates the overall system configuration and component connections.
To Next Page