Olympus OEP-3 - Page 62

1-56
OEP-3 V1 (UC)
110
Installation and Adjustment
Setting Up the Printer (Continued)
40&40
50&40
60&40
40&50
50&50
60&50
40&60
50&60
60&60
COLOR BALANCE
BAL X : 50 [1 – 50 – 99]
BAL Y : 50 [1 – 50 – 99]
BAL STEP : 10 [1 – 20]
TEST PRINT : PRESS [EXEC]
PRN SETUP : PRESS [ > ]
Q1 A 1
S
COLOR : 200
To perform rough adjustment
To perform color balance adjustment beyond the current color balance range,
increase the value of the BAL STEP.
2
Make a test print by repeating steps 5, 6, 7 and 8 in
“Adjusting the Color
Balance” on page 107.
3
Select the image with the best color balance among the 9 images, if you can
decide. Then display the values of BAL X and BAL Y by using the F, f, G or
g button.
Repeat steps 1 and 2 until you have obtained the best color balance.
4
Go back to step 10 in
“Adjusting the Color Balance
” on page 109.
If you change BAL STEP from 05 to 10, the color
balances of the test print are changed as
illustrated.
111
Installation and Adjustment
PRN SPEED : / HIGH
MOTION CHK
P
/c/ l /PRN/i/o/
RINTER SETUP
PRINTER SETUP COLOR : 200
/ COL / LAY / PRN / IN / OUT /
PRINT QTY. : 1 [ 1 ~ 9 ]
INTERVAL : OFF / ON
GAMMA : S / NORMAL / H
: OFF / ON
LOAD USER : 1 / 2 / 3 [ EXEC ]
SYSTEM : PRESS [ > ]
FUNCTION : PRESS [ > ]
C - BALANCE : PRESS [ > ]
Q1 A 1
S
Selecting the Operation Mode for Automatic Printing
Capabilities
You can control the printer using either of the following remote control units
connected to the REMOTE 2 or REMOTE 3 connector on the rear panel of the
printer.
• RM-91 Remote control unit (provided by Sony Corporation): Connected to the
REMOTE 2 connector
• FS-30 Foot switch (provided by Sony Corporation): Connected to the REMOTE
3 connector.
In addition, you can also remote control the printer by using a remote control unit
which sends the remote control signal to the Pin No.5 of the REMOTE 3
connector.
Using the menu, you can assign the desired functions to the remote control unit
connected to the REMOTE 2 or REMOTE 3 connector.
In addition, the printer can be remotely controlled by a pulse signal input to
REMOTE 2 or REMOTE 3. (See pages 131 and 132).
Also, you can control the printer using a personal computer.
For detailed information on controlling with the computer, contact your Olympus
representative or the nearest Olympus service center.
Note
The FS-36 foot switch (provided by Sony Corporation) is connected to REMOTE 2
to control the printer. However, the function of this foot switch cannot be assigned
using the menu.
1
Press the MENU button, then select PRN by pressing the G or g button.
The PRINTER SETUP menu appears on the source image.
1,7
2,4,6
3
5,6
Switch PRN to green by
pressing the G or g button.
Display PRN in capital letters by
pressing the G or g button.
Continue to the next page c